HuMANDATA original configuration tool "BBC[EDX-302]" for an USB-FPGA board, EDX-302, provides you
- FPGA Configuration
- Configuration Memory Access (Write/Read/Erase)
without a special download cable.
BBC[EDX-302] requires just only .bit file for both operations. You do not need to prepare an mcs file for configuration device. Software project files and source codes are offered to customize. (C++ Builder 11)
BBC[EDX-302] is tested under these OS below, and is not supported for Mac and Linux.
- Windows 11
- Windows 10
- Windows 8.1
- Windows 8
- Windows 7
Command Tab
・Target：FPGA
- Configuration : Configure the FPGA
- Reset : Reset the FPGA
NOTE : Set the configuration mode as slave serial
・Target：ROM
- Program : Program the configuration device
- Erase Only : Erase the configuration device (Only 1st sector)
- [...] : You can select a bit file to use.
- Dir : A directory part of the rbf file path.
- File : File name.
- Always Front : Keep the windows on top.
Option Tab
- Use default port description : Default USB port description of EDX-302 will be used.
- Save Setting : You can save the file path and other settings for next launch.
- Show System Message : You can see more detailed log.
- Find Ports : You can see ports which are detected on PC.
Use with command line arguments
You can set the file path and execute comfiguration.
| Command (Ignorecase) |
Followed Argument | Function | Note |
| -F | file path | Set the file path fields. | Both relative and absolute path are OK. Same directory of exe will be used when you set just only file name. |
| -C | none | Configure the FPGA. | -F is necessary |
| -A | none | Configure the FPGA. The done pin will not be checked after configuration. |
-F is necessary |
| -R | none | Reset the FPGA reset. | |
| -P | none | Program the configuration device. | -F is necessary |
| -E | none | Erase the configuration device. | |
| -N | none | Check the done pin condition. | |
| -DA | Port Description | Set an USB port A description | Optional |
| -DB | Port Description | Set an USB port B description | |
| -G | Positive integer | Set time to close. | The zero will keep the tool alive. Maximum value is 10. Default is 3. |
| -K | none | Do not save an ini file when close. |
| Exit Code | Result |
| 0 | Finished successfully |
| 1 | The done pin is high (-N command) |
| 2 | The done pin is low (-N command) |
| -1 | Finished with some error |
| -2 | File path is not set |
Note : Use start command with a /wait option command to get proper exit code.
Example of Usage
BBC[EDX-302].exe -f test.bit -c
BBC[EDX-302].exe -f ../../test.bit -p
Download
| Version | File | |
|---|---|---|
| BBC[EDX-302] tool | V11 |  Download |
| Project File (C++ Builder 11) | V11 | Request |
History
July 29, 2023 : Support for Windows 11 (V11)
April 18, 2018: Release
If you have questions or requests, please contact us.
[
]
