FT600/FT601 series
Last Updated: Wednesday, 28 October 2020
FT600 series is a product with new FTDI chip, FIFO bridge IC FT600, which supports USB3.0 SuperSpeed.
FT600
No | Description | FPGA | Series | Image | Features | DOC |
---|---|---|---|---|---|---|
1 | CycloneV USB-FPGA board | 5CEBA4F23C8N | EDA-009 | ![]() |
![]() ![]() ![]() ![]() |
|
2 | Kintex-7 USB-FPGA board | XC7K70T-1FBG484C XC7K160T-1FBG484C |
EDX-009 | ![]() |
![]() ![]() ![]() ![]() ![]() |
![]() |
3 | FT600 Evaluation Board | USB-106 | ![]() |
![]() |
![]() |
|
4 | FT601 Evaluation Board | USB-107 | ![]() |
![]() |
![]() |
Key Device Features
- Support for USB3.0 SuperSpeed (5Gbps), USB High Speed (480Mbps) and USB 2.0 Full Speed (12Mbps) transfer
- Available with 16bit wide parallel FIFO interface
- Supports 2 parallel slave FIFO bus protocols, with data bursting rate up to 200Mbps
- Supports multi channel FIFO interface
- Up to 8 configurable endpoints (pipes)
- Built-in 16kB FIFO data buffer RAM
- Supports multi voltage I/O: 1.8V, 2.5V and 3.3V (USB-106 supports only 3.3V)
- Configurable GPIO support
- Supports Remote Wakeup capability
- Programmable ROM
- Integrated 1V regulator
- Provides USB Battery Charger Detection (BC1.2.)
- Integrated power-on-reset circuit
- Extended operating temperature range: -40°C to 85°C
[ ]