PLCC68 series is very small, stamp size FPGA/CPLD modules designed to be used with 68pin PLCC sockets.

Some PLCC sockets have spacers on the inside top surface. For a single sided mounting module, you can use any type of PLCC socket. For a double sided mounting modules, you need to pay attention to select a PLCC socket. Some PLCC sockets are unusable due to the spacer's position and height.

Please take a look on this page for your consideration.

Model Description Image components on bottom side
AP68-01 MAX II PLCC68 CPLD Module Altera MAX II PLCC MODULE No
AP68-02 MAX V PLCC68 CPLD Module Altera MAX V PLCC MODULE No
AP68-03 Cyclone III PLCC68 FPGA Module Altera Cyclone III PLCC MODULE YES *
AP68-04 Cyclone III PLCC68 FPGA Module Altera Cyclone III PLCC MODULE YES *
AP68-06Z Cyclone V PLCC68 FPGA Module Altera Cyclone V PLCC MODULE YES *
AP68-07 Cyclone V PLCC68 FPGA Module Altera Cyclone V PLCC MODULE YES *
AP68-08 MAX 10 PLCC68 FPGA Module Altera Cyclone V PLCC MODULE YES *
AP68-09 Cyclone 10 LP U256 PLCC68 FPGA Module Altera Cyclone V PLCC MODULE YES *
XP68-01 Spartan-6 PLCC68 FPGA Module XILINX Spartan-6 PLCC FPGA MODULE YES *
XP68-02 Spartan-3AN PLCC68 FPGA Module XILINX Spartan-3AN PLCC FPGA MODULE YES *
XP68-03 Spartan-6 PLCC68 FPGA Module XILINX Spartan-6 PLCC FPGA MODULE YES *
XP68-04 Spartan-6 PLCC68 FPGA Module XILINX Spartan-6 PLCC FPGA MODULE YES *
XP68-05 Artix-7 PLCC68 FPGA Module XILINX Artix-7 PLCC FPGA MODULE YES *
XP68-06 Spartan-7 PLCC68 FPGA Module XILINX Spartan-7 PLCC FPGA MODULE YES *

* Note: cannot be mounted on some PLCC sockets


Surface Mount PLCC Socket

Most of surface mount PLCC sockets have no spacer in it, so it is usable with no problem.
As a picture above, inside top surface is flat. It is available for both single-sided and double sided mounting modules.

 


Through Hole PLCC Socket

There are four spacers on inside top surface. Following conditions should be met:
12.5 x 12.5 [mm] pitch, 1.5 [mm] in diameter.
When these conditions are met, both single-sided and double-sided are mountable.

 


Unusable PLCC Socket Example

This socket is not good for double-sided module because it has L-shape spacers. (But OK for signle-sided)
 


Click to Zoom

This is a picture of bottom side of XP68-01. No components are mounted at the red circles not to be obstacles for the PLCC socket's spacers. Green arrows point at module's spacers.

 


Summary

PLCC Socket

Double-sided
Modules
Single-sided
Modules

OK OK

NOTICE

Be care of back side

OK

NG OK
 
If you have any question, please feel free to contact us.

[]

Copyright © 2017-2024 HuMANDATA LTD. -  Altera (Intel) & AMD (Xilinx) FPGA Boards manufacturer in Japan - All Rights Reserved Sitemap