Performance evaluation report : ACC-009

Last Updated: Thursday, 07 September 2017

Performance evaluation report : ACC-009
Eye-diagram epsification differencies between ways of connection

 ACC-009 converts HuMANDATA's SIF40 standard interface into SMA connectors.
For your reference, please see the following Eye-diagram and specifications when we use ACC-009 to ouput fast serial transceiver(Tx) signals from the SIF40 connector.
Most pictures are available to zoom.

ACM-024 is used as a signal generator for measurement. The ACC-009 is connected to ACM-024's SIF40 connector to output fast serial signals.

Signal Spec:

Channel: 0(P)
Ref.Clk:125MHz
Rate:2.5Gbps
Swing:900mV
Pre-emphasis: 0%
Data: PRBS-10

 

Between Gen and OscilloEye DiagramJitter Analysis

Direct


Using conversion board
(HuMANDATA original)
 


conversion board

ACC-009

 

These datas show you transmission characteristics measured by network analyzer. The one of measured differential pair is connected to analyzer and the another is terminated by 50 Ohm resister.

 

Connection (Single Side)result (S21)Note

Direct

for calibration


conversion board

 


conversion board

ACC-009
 

[ ]

© HuMANDATA LTD. - Intel (Altera) & Xilinx FPGA Boards manufacturer in Japan - 2017 Sitemap