EDA-004 - HuMANDATA LTD.

Altera Cyclone III USB-FPGA board

*This series was discontinued.

Overview

EDA-004 is Altera's Hi-performance FPGA Cyclone III board. It's compact and very simple. 5.0V single external power supply operation.
You can configure the FPGA device using HuMANDATA original programming software BBC[EDA-004].

Cyclone FPGA Board ACM-022
Click to Zoom

Click to Zoom

Block Diagram

Block Diagram ACM-022
Click to Zoom

Specifications

Altera EP3C55F780C8N(Cyclone III FPGA 55K LE)

Feature	EP3C55F780C8N
Logic Elements	55856
PLLs	4
Maximum user I/O pins(Device)	377
Maximum user I/O pins(Board)	100
M9K RAM blocks	260
RAM bits	2,396,160
Multipliers	156

This table is for reference. Please refer to official data-sheets for certain information.

Power : 5.0 V single supply
- 1.2 V/2.5 V/3.3 V on-board regulators
- USB Bus-power is not available
Configuration Device(Altera EPCS16SI8N or EPCS16SI16N)
Resister-protected 100 I/O, PAD 100 mil (2.54 mm) grid
FPGA configuration through JTAG
FPGA configuration through USB
User communication through USB
(FT2232H Sync-FIFO mode is available)
50 MHz Oscillator(50 ppm)or External input
One User Push-Button Switch
Tree User LEDs
Two Status LEDs (Power, Done)
MRAM(EVERSPIN, MR2A16AYS35 256Kx16)
Power-on Reset signal for FPGA configuration
JTAG port(10 pin socket) for ByteBlaster[MV/II] or USB Blaster
High quality six layers PCB.(Immersion gold)
Credit-Card-Size 3.386" x 2.126" (86 x 54 mm)
ESD and Surge protection for USB
Tested all I/O
Non-use of 6 Restricted substances of RoHS directive
MADE IN JAPAN

Package Contents

Item	Image	Quantity
FPGA board (EDA-004)		1
USB cable (Type A to B)		1
Pin Headers		2
Sockets		2

There is no paper document such as user's manual and circuit schematic in the package.
Please download those documents from the link in the documentation section below.