USB-106 - HuMANDATA LTD.

USB-106 FT600 Evaluation Board

USB-106 is an evaluation board of FTDI's FT600. FT600 supports USB 3.0 SuperSpeed (5Gbps).
You can utilize this board for FT600 performance estimating, preproduction prototypes, USB communication interfaces for your application and more.

» Please also see other FT600 series products.

Overview

USB-106
Click to Zoom

Specifications (USB-106)

FT600 (FTDI)
USB3.0 B Connector
40-pin user interface
Operate from 5.0V or 3.3V power supply
On-board 3.3V regulator
Power-on reset IC
USB3.0 Cable (1.0m)
DIL 80-pin header for user I/F
All products are tested by connecting to a computer
ESD/Surge protection devices for USB signal lines
4 layer PCB with Immersion gold
2.244" x 2.48" (57 x 63 [mm])
Non-use of 6 Restricted substances of RoHS directive
MADE IN JAPAN

Specifications (FT600)

This is not a specification of USB-106 but of FT600.
For more details, please see FTDI's web site.

Support for USB3.0 SuperSpeed (5Gbps), USB High Speed (480Mbps) and USB 2.0 Full Speed (12Mbps) transfer
Available with either 16bit/32bit wide parallel FIFO interface
Supports 2 parallel slave FIFO bus protocols, with data bursting rate up to 200 MB/s
Supports multi channel FIFO interface
Up to 8 configurable endpoints (pipes)
Built-in 16kB FIFO data buffer RAM
Supports multi voltage I/O: 1.8V, 2.5V and 3.3V
Configurable GPIO support
Supports Remote Wakeup capability
Provides USB Battery Charger Detection
Integrated power-on-reset circuit
Extended operating temperature range: -40°C to 85°C

Reference Data

USB3.0 compliance test. Eye pattern of upstream tests.

click to zoom

USB2.0 compliance test. Eye pattern of upstream tests.

click to zoom

Package Contents

Item	Image	Quantity
USB-106		1
USB cable (Type A to B)		1
80-pin header		1

There is no paper document such as user's manual and circuit schematic in the package.
Please download those documents from the link in the documentation section below.